- ページ 5

サーモスタット Danfoss Basic Plus2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Danfoss Basic Plus2 8 ページ。 Room thermostats floor heating

ページを印刷する

User Guide

Child Safety Lock

Press "M" and hold. Press ">" within 6 seconds to lock all buttons.

Operate again to exit the child safety lock.

Set Control Parameters

Press "M" button for 6 seconds to enter the parameter setting

mode. Press "M" for parameter selection and set the parameter

range via "<" or ">". Complete all adjustments. To exit WT-P/PR,

press

, which is available for this purpose (automatic exit after

30 seconds with no operation). To exit WT-D/DR, wait for automat-

ic exit (30 seconds). The upper digits indicate the parameter num-

ber. The digits indicate the set value as follows.

No. Parameter set-

Settings range

tings

P01 Working mode

01: Manual ; 02: APT

P02 Temperature con-

01: Only room temp.;

trol mode

02: Room and floor

temp.; 03: Only floor

temp.

Error Messages

Error messages are displayed as follows:

▪ E1 = room sensor failure

▪ E2 = floor sensor failure

▪ EE = EEPROM failure

▪ Lo = temperature lower than 0 °C

▪ HI = temperature higher than 50 °C

All relay output will be turned off in all cases.

Danfoss Heating Solutions

Basic Plus

Room Thermostats Floor Heating

No. Parameter set-

P03 High room temp.

P04 Low room temp.

P05 Floor temp. limita-

P06 Floor temp. limita-

P07 High floor temp.

P08 Low floor temp.

P09 Frost protection

Factory default

P10 Frost protection

WT-

D/DR

P/PR

P11 Timer display op-

P12 Room temp. dis-

P03 to P08 appear on relevant temperature control mode.

Settings range

tings

5-35 °C (only for 01and

limit

02 in P02)

5-35 °C (only for 01and

limit

02 in P02)

01: High temp. limita-

tion mode

tion: 02: Low temp. lim-

itation (only for 02 in

P02)

20-45 °C (only for 02 in

tion setpoint

P02)

20-45 °C (only for 03 in

limit

P02)

20-45 °C (only for 03 in

limit

P02)

01: Enable; 02: Disable

5-17 °C

setpoint

01: 24 h; 02: 12 h

tion

01: No display current

play option at

temp.; 02: Display cur-

shutdown

rent temp.

VUCUA102

Factory default

WT-

D/DR

P/PR

30 °C

5 °C

35 °C

20 °C

5 °C