- ページ 14

エンジン 3T-Components 3T-MOTORS 3T45-20RのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。3T-Components 3T-MOTORS 3T45-20R 20 ページ。 Radio shutter / awning motors with mechanical limit switches
3T-Components 3T-MOTORS 3T45-20R にも: 据付・取扱説明書 (20 ページ)

3T-Components 3T-MOTORS 3T45-20R 据付・取扱説明書
INSTALLATION INSTRUCTIONS
Slide the side bearing with universal bearing onto the support tube & fasten.
Ensure that the motor square spigot is properly engaged in the universal bearing.
Secure the motor square spigot with the supplied cotter pin.
Attach the cover to the side bearing.
Install awning & release fuses.
3.9
Support tube
Side bearing &
Universal bearing
Awning motor wiring:
4
Connect the radio awning motor to the mains.
The electrical connection of the awning motor and control may only be carried out by qualified personnel.
If the motor runs in the opposite direction after installation, the direction of rotation of the radio motor must be changed
via the radio transmitter (p. 16).
Power grid
230 V / 50 Hz
1) brown / black = L1 / Phase
2) blue = N Neutral conductor
3) green/yellow = PE Protective conductor

Programming radio transmitter

5
Teach radio transmitter to shutter motor. See Programming radio transmitter > Teaching hand-held transmitter to 3T radio motor type R (page 16).
If the direction of rotation is reversed, please change it with the taught-in radio handheld transmitter > Change direction of rotation of radio motor (page 16).
>
fig. 3.11
>
fig. 3.12
3.10
1 (L1)
2 (N)
3 (PE)
>
fig. 3.9
>
fig. 3.10
3.11
Cotter pin
3.12
Cover
Radio awning motor
230 V / 50 Hz
1 (L1)
2 (N)
3 (PE)
1) brown / black = L1 / Phase
2) blue = N Neutral conductor
3) green/yellow = PE Protective conductor
3T-MOTORS Radio tubular motors | Installation instructions
Side bearing
14