- ページ 2

サーモスタット Danfoss TP6000MのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Danfoss TP6000M 6 ページ。 Electronic programmable room thermostats

ページを印刷する

Important note; Resetting the unit - To ensure correct operation press reset button

before commencing with programming.

Important note; If no buttons are pressed for two minutes the unit will automatically go

back to run mode. All changes made will be saved.

B) U

SER PREFERENCES

Before programming the thermostat it is recommended that the user preferences as regards

clock display and temperature scale are set. Details of the available user preferences are shown

below:

Clock display: press both - and

AM/PM & 24 hour. Repeat to return to original setting.

Temperature scale: to select between centigrade and farenheit temperature displays, follow

the steps below:

1. Press - and

buttons for 2 seconds to enter temperature display mode

2. Press - and + buttons for 2 seconds to change between centrigrade and farenheit display

3.Press - and

buttons for 2 seconds to change display back to time display mode prior to

programming.

Display actual room temperature: to permanently display actual room temperature press both

- and

and hold for 2 seconds. Repeat to return to time display.

C) S

ETTING THE TIME OF DAY AND DAY OF WEEK

1 Press PROG button to enter programming mode.

2. Press + or – buttons to adjust time of day, if in AM/PM mode remember to ensure that AM/PM

setting is correct.

3. Press PROG to move on to select current day of week.

4. Press + or - button repeatedly until correct day of week is displayed. Day 7 is Sunday.

5. Press PROG button to advance to "Programming event times and temperatures".

D) P

ROGRAMMING EVENT TIMES AND TEMPERATURES

Reminder - The thermostat can be set by the installer to provide 2 or 4 programme events per

day. The thermostat provides 5-day / 2-day Programming with one set of programmes for days

1-5, (Monday to Friday), and another set of programmes for days 6-7, (Saturday and Sunday).

Reminder - If thermostat has been set by building owner or installer for 2 events per day, only

2 events can be programmed.

Reminder – The time setting of all events are made in increments of 10 minutes.

Setting the time and temperatures events for Days 1-5.

1. Press + or – buttons to adjust event time for event 1.

buttons and hold for 2 seconds to change display between

LCD DISPLAYS

PROG

BUTTONS

RESET

plus

then

plus

then

plus

then