- ページ 2
コントロールユニット Danfoss vlt soft starter mcd 500のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Danfoss vlt soft starter mcd 500 6 ページ。 Usb module
Danfoss vlt soft starter mcd 500 にも： 取付説明書 (17 ページ), インストレーション・インストラクション (5 ページ)
ページを印刷する
Installation Instructions
4 Installation
4.1 IP20 Protection for MCD 200, MCD5-0131B
~ MCD5-0215B, and MCD5-0245C
MCD 200 and MCD 500 (enclosure sizes G2 and G3C) models
use rubber finger guards. Rubber finger guards provide IP20
protection when used with cable of diameter 22 mm or
greater.
Installation
1.
Place 3 finger guards side by side in 1 retaining
bracket. Align the assembly so that the screw holes
in the bracket match the screw holes in the soft
starter.
MCD 200 only: Remove the 2 top screws from the
casing around the power terminals.
MCD 500 G3C enclosure size models only: Fit the
finger guard base chassis to the MCD 500 enclosure
first before installing rubber finger guards.
2.
Feed each power cable through the narrow end of
each finger guard. Connect the cables to the
appropriate terminals on the soft starter.
3.
If the cables do not fit through the finger guards,
shorten the finger guards at the narrow end to make
a bigger opening.
4.
Screw the retaining bracket to the soft starter.
MCD 200 only: Use the screws from step 1 to attach
the retaining bracket to the soft starter casing.
MCD 500 G3C enclosure size models only: Fit the
finger guard cover over the finger guard base chassis
to complete the arrangement.
5.
Repeat steps 1–4 for the other set of terminals.
Illustration 4.1 Finger Guard Installation for MCD 200
2
Finger Guards
®
VLT
Soft Starter MCD 200/MCD 500
Illustration 4.2 Finger Guard Installation for MCD 500 G2 Enclosure
Size
Table 4.1 Legend to Illustration 4.1 and Illustration 4.2
Illustration 4.3 Finger Guard Installation for MCD 500 G3C
Enclosure Size
Danfoss A/S © 04/2016 All rights reserved.
1
Screws
2
Retaining bracket
3
Finger guards
1
Screws
2
Retaining bracket
3
Finger guards
4
Finger guard base chassis
5
Top cover
MI17A602