- ページ 8

水ポンプ Danfoss APP 21-43のPDF 分解と組み立ての説明をオンラインで閲覧またはダウンロードできます。Danfoss APP 21-43 14 ページ。 Disassembling and assembling
Danfoss APP 21-43 にも：サービスマニュアル (20 ページ)

ページを印刷する

Instruction

Disassembling and assembling APP 21-43

16. Retainer guide, retainer ball and retainer plate

must be mounted in the order indicated in

picture below.

18. Place retainer plate in cylinder barrel.

Note: If pistons are replaced, place new

pistons in clean filtered water for a couple of

minutes. Exercise piston shoes to make them

"run" smoother.

20. Lubricate piston shoes and swash plate with

clean filtered water.

22. Place three bolts in mounting flange.

Turn each bolt one round at a time to ensure

mounting flange is mounted as straight

downwards as possible. Be careful not to

squeeze O-ring.

180R9121 / 521B1018 / DKCFN.PI.013.A4.02 / 10.2013

17. Ensure that retainer plate is oriented correctly,

ie with its slant surfaces pointing downwards.

19. Place pistons in retainingplate and cylinder

barrel. When pistons are placed, tilt retaining

plate for easier placement of swash plate.

If swash plate has been disassembled from

mounting flange, see page 10 for assembly of

swash plate.

21. Remember to place the guide pin in the

housing.

23. Screw in the rest of the bolts and cross tighten

all screws to a torque of 30 +/- 2 Nm.

Note: Screws for lifting eye are shorter than the

rest.