- ページ 3

ボイラー Dunkirk EXCELSIOR SeriesのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Dunkirk EXCELSIOR Series 4 ページ。 Oil fired boiler, knockdown assembly

10.

Attach the burner harness zip tie to right side jacket. If

no hole is present, drill 1/8" dia. See

Attach the lower rear panel. The tabs fit into the slots

11.

in the side panels. Do not attach the upper rear panel.

See

Figure 7.

(Nipples removed for clarity)

KNOCKDOWN BOILER ASSEMBLY

Figure 6

11"

Figure

Figure 7

Attach the front control panel. With the screws provided,

12.

attach the bottom screws, then place the panel onto the

screws using the notches in the panel. See

Then, attach the top using the other two screws.

13.

Tighten down the bolts mentioned step 6.

14.

Attach the 2 hinges to the Top Panel using the snap

rivets. Then, place the top panel over the sides and

the front. Be sure the plastic dowels fit into the holes

on the top of the side panels. (If the flanges cover

holes, re-read step number 2.) See

Figure

Figure 8

Figure

Figure 9