- ページ 11

水ポンプ Danfoss D1P130のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Danfoss D1P130 15 ページ。 Axial piston pump, variable displacement

User Manual

ATEX certified D1P 130/145/193/260

Installation, operation and maintenance

Operation

Danfoss | August 2021

The purpose of this section is to indicate the necessary procedures to perform the pump start up.

Before performing the first pump start up, the following points have to be checked.

Hydraulic components must be installed in accordance with their individual instruction.

1. To avoid contamination, plastic plugs in connection ports must not be removed until just before

connections are made.

2. Make sure the pump hydraulic connections allow the pump to rotate in the desired direction. For

pumps with standard direction of rotation:

Clockwise rotation (viewed facing the output shaft) with inlet pressure in the front port.

Counter-clockwise rotation (viewed facing the output shaft) with inlet pressure in the rear port.

Generic illustration shown.

3. Select the hydraulic fluid as specified in

4. Ensure full contact between pump mounting flange and connecting part.

Avoid pressing the pump into place by tightening the fixing bolts. Avoid unsuitable seal materials, for

example, twine and Teflon, on threaded unions. Use only the seals supplied, such as O-rings, steel

washers.

5. Make sure that all couplings are completely tightened to prevent leakage.

Do not use more torque than the maximum values given in the instructions.

6. Check to make sure the purity of the oil is greater than 22/20/16 (ISO 4406-1999) and always use a

filter when replenishing the system.

Warning

The pump must be filled with fluid prior to any load applications.

Oil types / Operating

fluids.

BC376161003883en-000101 | 11