- ページ 5
水ポンプ Danfoss Nessie Plug&Spray NPS 10VSのPDF 設置および試運転の手順をオンラインで閲覧またはダウンロードできます。Danfoss Nessie Plug&Spray NPS 10VS 12 ページ。
8.3 Additional wiring of the FCM 300 drive motor
Fault relay
8.4 Units with electrical connecting box
Constant speed version (CS)
Plug&Spray
units equipped with electrical connecting box from fac-
TM
tory are fully wired and prepared for direct power supply connection.
The following connections must be made:
8.5 Units with electrical connecting box
Variable speed version (VS)
Plug&Spray
TM
units equipped with electrical connecting box from fac-
tory are fully wired and prepared for direct power supply connection.
The operator's control is placed in the front panel of the drive motor
connecting box. The following connections must be made:
The FCM 300 drive motor provides numerous possibilities for addi-
tional connections to the control system. As minimum the following
connections are recommended:
• Start/Stop
• Reset (push button)
• Fault indication
The low-pressure switch and the high-temperature switch are
integrated in the safety loop of the FCM 300 from factory (please see
diagram).
• Motor coast, inverse
Please refer to the FCM 300 instructions for detailed information.
Pressure transmitter
Temperature switch
Pressure switch
• 3-phase power supply (3 × 400 V)
• Start-signal through external potential-free contact
• Fault relay
Please refer to the wiring diagram delivered with the system.
• 3-phase power supply (3 × 400 V)
• Start-signal through external potential-free contact
• Fault relay
Please refer to the wiring diagram and the manual delivered with the
FCM 300 drive motor.
521B0881 DKCFN.PI.020.F1.02
Terminal 4
Terminal 3
Relay X 102
Terminal 5
Feedback
No operation
Reset
Start
Motor coast inverse
24 V DC/25 mA supply
5