- ページ 11

水ポンプ Danfoss PAHT 256-308のPDF インストラクションをオンラインで閲覧またはダウンロードできます。Danfoss PAHT 256-308 20 ページ。 Paht and paht g 256-308 disassembling and assembling

Instruction

Disassembling and

assembling of cylinder

barrel and valve plate

Disassembling and assembling PAHT and PAHT G 256-308

1. Push a screwdriver into the hole between

cylinder barrel and valve plate. Carefully

push downward the screwdriver so that it

makes a gap between cylinder barrel and

valve plate. Use this gap to put in another

screwdriver and loosen the valve plate

from the cylinder barrel.

3. Lubricate the new O-rings/back-up rings

and the liners in the cylinder barrel with

clean filtered water. Lower the valve plate

upside down on the cylinder barrel. Place

the press bush for valve plate (provided in

tool set) like on the picture. Screw the bolt

into the shaft of the cylinder barrel. Turn

the nut slowly clockwise. The valve plate

must slide carefully into the cylinder

barrel. Stop when the gap between

cylinder barrel and valve plate is 1-2 mm.

180R9268 / 521B1236 / DKCFN.PI.011.B3.02 / 01.2015

Mount

backup

rings first

Mount then

O-rings

2. Remove the O-rings and backup rings. If

they have been removed they can not be

reused.

Mount the new back-up rings on the valve

plate first and then mount the O-rings.

4. Remove the press bush again by screwing

the nut counter-clockwise.

Turn the nut slowly clockwise. The valve

plate must slide gently into the cylinder

barrel. Stop when the gap between

cylinder barrel and valve plate is 1-2 mm.