- ページ 8
ガーデンハウス Dunster House ADAM II H4-1824ASHのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dunster House ADAM II H4-1824ASH 15 ページ。
ページを印刷するSTEP 2: FLOOR
Items:
8x
ST-PT35351750 (Bearer)
1x
MFP - 1750x1220x10
1x
MFP - 1750x1080x10
20x 70mm SCREW (6/Bearer)
6x
50mm SCREW
Bearer layout (1.0)
MFP - 1750x1220x10
365
365
STEP 3: PANELS
Items:
1x
PANEL CB - 1750x2134 (REAR PANEL)
1x
PANEL DB - 1750x2134 (FRONT PANEL)
1x
PANEL AA + AI - 2300x1897 (SIDE PANEL NO WINDOW)
1x
PANEL BG + BM - 2300x1897 (SIDE PANEL WITH WINDOW)
4x
ST-PT35351875
6x
90mm SCREW
20x 70mm Screw
16x 50mm Screw
Principle of panels installation 1.0
FRONT PANEL
90mm SCREW
70mm SCREW
Pre-drill parts before fixing with screws
2a) Ensure the base is level. Space bearers at the
specified distance as shown in the the diagram below
(1.0). If the bearer layout consists of double bearers, use
50mm screws to secure them as shown in the image to
the right (1.1).
2b) Secure the MFP to the bearers with 35mm screws all
equally spaced. There should be a 70mm space between
the ends of the bearer and the screw.
MFP - 1750x1080x10
350
315
315
310
2300
Pre-drill parts before fixing with screws
Assembly Steps
Principle of floor board(s) installation
Use 35mm screws. Keep equal distance between
screws. Use same amount of screws per each
bearer.
ST-PT35351750
FRONT
ST-PT35351875
50mm Screw
SIDE PANEL
70mm SCREW
Joining double bearer (1.1)
Use 50mm screws.
50mm SCREW
Approx. 70mm
3a) Position front panel as shown in the
diagram below. Use 3x 90mm screws per
each side (not in the doorway) to secure
the front panel to the bearer. Use 3x
70mm screws to secure the panel to the
bearers (in the doorway).
3b) Use 4x 50mm screws equally spaced
screws to secure ST-PT35351875 to the
front panel. Refer to image on the left.
3c) Position side panel as shown and use
1x 70mm per each bearer to secure it to
the floor.
3d) Use 4x 50mm screws spaced
approximately 500mm apart to secure the
side panel to the front panel.
3e) Repeat these steps for all remaining
panels except the rear panel. Use 5x
70mm screws all equally spaced for the
rear panel into the floor.
Double
Bearer
35mm SCREW
Page 8