- ページ 6

遊び場機器 Dunster House MonkeyFort Wilderness 2のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dunster House MonkeyFort Wilderness 2 20 ページ。

This play system is intended for family domestic use and to be used for outdoor use only. This climbing frame is

suitable for children aged between 3-14 years and up to a maximum weight of 50kg per child and a maximum of 4 children

at any time but only one child can play on the tower platform. Please ensure that you follow the instructions carefully.

Pre-drill all screw holes with a 3mm drill bit.

If the pre-drilled bolt holes are slightly tight, use a hammer to knock them through. Component parts are listed on the

previous pages and referred to in the instructions by their component name. Adult assembly is required.

Warning! Not suitable for children under 36 months. Children under this age may fall off and not be

able to sufficiently support themselves.

Warning! Do not position the Fort over concrete, asphalt or any other hard surface or near to any

water hazards.

Warning! It is recommended that you place the Fort on a level surface at least 2m from any structure

or obstruction such as a fence, garage, house, overhanging branches, laundry lines or

electrical wires.

Warning! Do not overtighten nuts and screws as this may cause them to shear and potentially cause

structural failure.

Warning! Do not modify your play system as this may adversely affect its function and will also void

your warranty.

Warning! Only to be used under adult supervision.

Step 1 - required components for two ladders

4 of C40138B - 86x43x2225

8 of C4038A - 44x44x550 - rungs

Lay the items on the ground first and position the components before fixing. Make sure the grooves on the rungs are

facing the same direction as depicted. Fix components together using 4x50mm countersunk screws. Drive them through

(as shown in Figure 1) from the top and bottom of the side parts (C40138B) into the rungs.

When pre-drilling, do not drill through the rungs.

Vertical ladder x2

direction - grooves on the rungs

Pre-drill all screw holes with a 3mm drill bit.

Assembly Instructions for MonkeyFort Wilderness II

C40138B - 86x43x2225

C4038A - 44x44x550 - rungs

2225

Warnings

2225

550

C40138B - 86x43x2225

'Grooved' part of the rungs

need to be in this position.

32 of 4x50mm countersunk screw

4x50mm

countersunk screw

4x50mm

countersunk screw

Figure 1

Rung

Page 5