- ページ 12

エアコン Duo-Therm 57915.421のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Duo-Therm 57915.421 17 ページ。 Roof top air conditioner/heat pump
Duo-Therm 57915.421 にも：取付説明書 (17 ページ)

ページを印刷する

Installing unit with 3105007.XXX or 3105935.XXX

Return Air Cover.

A. INSTALLATION OF CEILING TEMPLATE

Check gasket alignment of the air conditioner over

the roof opening and adjust if necessary. Unit may

be moved from below by slightly lifting and sliding.

See FIG. 11A.

Remove return air cover and ceiling template from

the 3105007.XXX or 3105935.XXX kit carton.

FIG.

10A

Ceiling Template

Return Air

Grill

Locate 1/4 " unit mounting bolts in the parts pack-

age.

Hold the ceiling template up to the 14-1/4" x 14-1/

4" (±1/8") opening. Be sure the large plate faces

the rear of the RV.

FIG. 11A

Center Unit From Below

4 Wire Thermostat

Cable

Installing unit with 3105007.XXX or 3105935.XXX

Return Air Cover, continued on page 12, column A.

10. INSTALLATION OF AIR CONDITIONER

Divider Plate

Return Air

Cover

Gasket

AC Power

Supply

Pull Conduit Down

INSTALLATION INSTRUCTIONS DUCTED BI-METAL

Installing unit with 3308120.XXX Genesis Air Filtra-

tion System.

Note: A 12VDC power source is required for this installa-

tion. See Section 5. B. Paragraph 6

A. INSTALLATION OF FOAM DIVIDER

1. Locate the foam divider and insert it corner to cor-

ner in the 14-1/4" x 14-1/4" (±1/8") opening with

the adhesive tape up (Do not remove paper to ex-

pose adhesive). The foam divider should be level

with the ceiling (±1/4"). Tear off the excess at the

FIG. 10B

Base Pan

Upside

Down

Foam

Divider

Place Foam Divider in

(14-1/4" x 14-1/4" (±1/8")

Ceiling Opening against

Base Pan Bottom

pre-cut perforations in divider. See FIG. 10B.

2. Peel the paper off of the foam divider and stick it in

place on the center of the rear edge of the return air

FIG. 11B

Adhesive

Peel Off Paper - Center Divider - Stick To

Rear Flange On Ceiling Template

opening on the ceiling template See FIG. 11B.

B. INSTALL CEILING TEMPLATE

1. Position the electrical control box towards the front

of the opening with all of the system control wires

connected to the control box. Place the ceiling tem-

plate up to the return air opening in the ceiling. See

FIG. 12B.

Wires Connected To

Control Box

FIG. 12B

Vehicle

Front

Installing unit with 3308120.XXX Genesis Air Filtration

System, continued on page 13, column B.

Do Not Peel Tape Off

Adhesive

Ceiling

Foam Divider Ceiling

(±1/4")

Level

Tear Off

Excess

Foam Divider

Control

Box

Base

Pan