- ページ 7
浄水器 Duo-Therm GENESIS 3308120 SeriesのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Duo-Therm GENESIS 3308120 Series 8 ページ。 Air filtration system
ページを印刷するc. Peel tape to expose adhesive. Wedge the
divider between center duct and bottom of
unit.
d. Stick foam weather strip (not provided) on
the top side of the ceiling template to seal
the gap between it and the center duct. Use
a soft piece of foam weather strip 1 x 3/4 x
10 inches. See Figure 6.
FIG. 6
Weather Strip
e. Place the ceiling template over the return
air opening. Start each mounting bolt through
the ceiling template and up into the base
pan by hand. Install a wood screw in each
end of the ceiling template. This insures a
tight fit of the return air cover to the ceiling.
Evenly tighten mounting bolts to compress
the roof gasket to 1/2", this will be a torque
of 40 - 50 Inch Pounds. The bolts are self
locking so over tightening is not necessary.
f.
Cut out bottom of the center duct allowing
the discharge of air to flow out the opening
in the ceiling template.
g. Proceed on from Steps G - L.
D. Peel the protective paper tape off of the divider and place
it on the center of the rear edge of return air opening on
the ceiling template. See figure 7.
Adhesive
FIG. 7
Center And Stick Foam Divider
To Flange On Ceiling Template
Stick Weather Strip to Top
of Ceiling Template
Ceiling
Template
Foam
Divider
Ceiling
Template
3308120.XXX GENESIS AIR FILTRATION SYSTEM
E. Place the ceiling template up into the return air opening
in the ceiling. Start each mounting bolt by hand through
the ceiling template and up into the base pan. Install a
wood screw in each end of the ceiling template. This
insures a tight fit of the return air cover to the ceiling.
Secure the control box to the ceiling template with thread
cutting screw. See figure 8A and 8B.
FIG. 8A
Brisk Air Models Mount
Control Box on Edge To
The Flange on Ceiling
Template
Vehicle
Front
FIG. 8B
Penguin Models Lay
Control Box Flat On Top
Of Ceiling Template
Vehicle
Front
F. Evenly tighten mounting bolts to compress the roof
gasket to 1/2", this will be 40 - 50 Inch Pounds of torque.
The bolts are self locking so over tightening is not
necessary.
If bolts are left loose there may not be an ad-
equate roof seal or if over tightened, damage
may occur to the air conditioner base or ceil-
ing template. Tighten to torque specifications
listed in this manual.
7
Control Box
Three
Screws
Control Box
Two
Screws
CAUTION