- ページ 7

自動車アクセサリー Free2Move eSolutions eProWallboxのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Free2Move eSolutions eProWallbox 11 ページ。

3.1

Energy meter Configuration

When powering up the Power Meter for the first time, tap&hold for 1.5 second, the

central display button, at the bottom, until the display shows the page where to insert

the password, initially set to 0000.

You can edit each value using left or right display button and confirm each time by

tap&holding the central display button.

For the three-phase Power Meter only, the system mode: 3Pn

To configure the Power Meter, tap&hold the left display button and set:

Modbus address: 1

BaudRate: 38.4 kbps

Parity bit: Even

Set the model of Power Meter installed on

Parameter: DPM_TYPE

This field allows to select the Power Meter model installed

UUID:

f0f924f8-34ce-4f1d-9791-b1b19ff3ffe4

TYPE:

Uint8, select UINT8 on the app

VALUE:

00 → FINDER 3ph (212)

01 → FINDER 1ph (210)

02 → GAVAZZI EM330DINAV53HS1X

03 → GAVAZZI EM111DINAV51XS1X

If installed, set the Transformer Ratio KI on

Parameter: TRANSFORMER_RATIO_KI

This value allows to set the Current Transformer ratio according to the installed

sensors. The value on the app is expressed in Hexadecimal

UUID:

0c8d04fc-247c-4119-ab10-77ad3779310c

TYPE:

Uint32, select UINT32 on the app

VALUE:

Set the Transformer Ratio KI according to the values printed on the sensor.

E.g. 100/5 → KI = 20 (Hex value → 14)

150/5 → KI = 30 (Hex value → 1E)

Installation manual - Annex

A d v a n c e d f u n c t i o n a l i t i e s s e t u p

nRF Connect

app: