- ページ 6

アンプ AudioControl ACX-300.2のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AudioControl ACX-300.2 12 ページ。 Compact high power all-weather 2-channel amplifier

ページを印刷する

Quick Start

Here are a few general steps to get your ACX-300.2 amplifier up and

running:

1. Undo the +12V and Ground connections to the vehicle battery

before making any connections to the amplifier.

2. Pick a mounting location that will provide access to the controls

and connections, provide plenty of good ventilation.

3. The ACX-300.2 amplifier needs to be securely mounted using the

four mounting holes located in each corner.

Before drilling any holes, take every precaution to prevent

any damage to fuel lines, power and other electrical wir-

ing, hydraulic brake lines, and other systems, that might compro-

mise vehicle safety.

5. When making connections, designate red RCA plugs as right,

and designate white, black, or gray plugs as left. This is a good

idea for consistency.

6. Use quality interconnect cables.

7. Connect the +12V input wire on the included wiring harness

assembly to the +12V terminal of the vehicle battery, using the

appropriate gauge wire.

8. Connect the Ground wire of the power wiring harness assembly

to a ground source such as the negative battery terminal, vehicle

chassis or other ground source, using the same wire gauge as

the +12V power wire.

9. Connect the remote power terminal of the unit to the remote

turn-on switch of your source unit. Alternatively, you can skip

this connection and use the GTO™ Signal sensing.

10. Connect your audio inputs to the unit – either speaker-level or

line-level RCA... not both.

11. Connect your loudspeakers (minimum impedance of 2 Ohms

stereo, or 4 Ohms bridged mono).

12. When all connections are made, reconnect the vehicle battery.

13. Adjust your gain settings to maximize your signal level.

14. Set the ACX-300.2 crossovers to the frequency recommended by

the loudspeaker manufacturer.

15. Enjoy the drive!

ACX-300.2

Quick Start Guide