- ページ 8
アンプ AudioControl Architect 1160のPDF インストーラーズマニュアルをオンラインで閲覧またはダウンロードできます。AudioControl Architect 1160 9 ページ。 16 channel/ power amplifier/ speaker optimizer/ ethernet interface
ページを印刷する
A Guided tour Of
the Architect
Ê Ë
Front Panel
Ê
Stereo Speaker Equalization controls - This
array of knobs provide up to 12dB boost or cut
at 75Hz, 250Hz, 700Hz, 2500Hz and 12KHz.
After initial adjustment the only time you
would change the control settings are 1) if you
connect different speakers into the system, 2)
if (assuming the speakers aren't built-in) you
move them significantly, such as from a book-
shelf to floor stands, or 3) if your room acous-
tics change through addition or rearrangement
of furniture, wall or floor coverings, large hairy
dogs, etc. Note: There is a clear security cover
available as an option to cover these controls.
Ë
Channel Status LED's - These dual-color
LED's serve two purposes. First they illumi-
nate Blue when the corresponding channel is
active and operating properly. The second
function of the status LED is to turn Red if
something has caused that zone to go into
protection.
4
1160 Series
tm
®
Ì Í
Ì
Protection LED - This LED also has two
faces. In normal operation it glows Blue when
the remote power trigger is active and the
Architect is in stand-by. If the Protection LED
turns Red, then one of the internal protection
circuits have come into use. All the protection
circuits automatically reset themselves when
the problem causing the fault has been fixed.
Í
Power LED - Nothing too tricky here...when
you have the Master Power switch on the back
panel turned on and the Architect is plugged
into an active AC outlet, this little Blue light
will shine forth.
Model 1160, Model 1161