- ページ 8

クロスオーバー AudioControl HPXのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AudioControl HPX 20 ページ。 In-dash processor and crossover

7. Power Connections: This nifty connector is a god-

send to anyone who has tried to wire up their gear with their

head crammed under the dash. You can wire up the power,

ground, remote turn-on, and illumination from the conve-

nience of the driver's seat and then casually plug it in the

back of your HPX.

Figure 3: Top View of HPX

Owner's Enjoyment Manual

8. Output Jacks: Next to the inputs are the outputs

which should be connected to the front, rear and subwoofer

amplifiers, if applicable. Note: Depending upon your system

application, you have the ability to have the highpass

outputs play full range by changing the CROSSOVER

jumpers under the chassis top.

9. Inputs: The HPX has 2 sets of inputs, MAIN and

SPEAKER LEVEL. These inputs should get their signals from

the main source unit/head unit and should attach to either

RCA jacks or speaker leads that are coming out of your source

unit.

10. Balanced Input Selector: Located under the

cover and behind the input connectors are jumpers that

allow you to utilize or bypass the balanced input circuitry.

Although it is shipped in the balanced mode, which is best, it

may be necessary to change this depending upon the

configuration of the components you use. To change this,

move the appropriate jumper on the 3-pin header.

11. Input Gain Control: These potentiometers (AKA

"pots") are used to increase the amount of signal voltage to

your power amplifiers. With these controls, you can provide