- ページ 7
音楽ミキサー Audiodesign PAMX3.122のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Audiodesign PAMX3.122 8 ページ。 Professional mixer
ページを印刷するPROFESSIONAL MIXER
SET UP MEMO
PAGE 10
PAMX3
Serie
Control panel
1
REC OUT:
These two RCA connectors can output low level stereo signal (left and right) for tape recorder.
2
2TK IN:
These two RCA
MAIN OUT (L, R)
3
These four connectors are all main output sockets of this mixer, two XLR connectors are balanced and two phone
jacks are unbalanced.
SUB OUT1,2 group output sockets
4
These two connectors are group output sockets of this mixer, they are unbalanced.
5
HEADPHONE stereo headphone socket
A set of stereo headphones can be connected to this phone jack. Normally, the headphones can monitor the same
signal as which sent to the each channel, when any PFL switch is pressed, the signal of the input channel after the
equalizer will be monitored.
6
EFF SEND ：
This is jack to send the output signals to the external effector.
7
AUX RET:
These are two auxiliary input phone jacks. The rated input level is -10dB.
Only connect the output of your source device to L/MOMO if the source is mono, thus the right signal is same as
the left.
8
AUX1~4 SEND:
These are unbalanced phone jacks for sending auxiliary output signals. They can be linked to a monitor outside or
linked to a sub power amplifier.
PROFESSIONAL MIXER
1
REC OUT
L
R
L
R
2
2
1
1
2
2
1
1
3
3
3
3
2
L
R
2TK IN
BALANCED
BALANCED
AUX1
AUX2
L/MONO
MAIN L OUT
MAIN R OUT
8
AUX3
AUX4
R
AUX SEND
AUX RET
SUB1 OUT
SUB2 OUT
7
4
connectors are unbalanced input
for the play input signal, rate input level: -10dB.
PAMX3
Serie
CONTROL PANEL
3
MAIN OUT
1 GROUND
2 HOT (+)
3 COLD ( )
6
EFF SEND
5
PHONES
PAGE 7