- ページ 7
バスタブ Freedom Bathtubs APWHY1241PAのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Freedom Bathtubs APWHY1241PA 9 ページ。 Walk in tub
ページを印刷するMAINTENANCE
Please make sure that the power is disconnected before doing any maintenance.
(1).
Keep the bathtub clean and neat
(2).
DO NOT use strong acids or alkali liquids to clean the bathtub or xtures
(3).
DO NOT allow the tub to run for more than 3 hours continuously
(4).
When cleaning the shell and oor of the bathtub, please use the soft and dry cloth. If there is light amount of dirt, use t he soft
cloth or sponge to clean with a non
(5).
Use a detergent that is specially made for acrylic tubs. The following substances are not to be used: acids or alkali solutions,
acetone product. If these products are used, damage to the tub and accessories may occur and the warranty will be void.
(6).
Don't use sharp obje cts to hit or strike the surface of the acrylic, glass and metal parts to avoid damaging the nish. Don't use
coarse or abrasive cleaners to clean the surface of acrylic, glass and metal parts to avoid damaging the surface.
(7).
Frequently check power lines,
TROUBLESHOOTING GUIDE
Problem
Pump does not work
Pump is making strange noises
GFCI breaker / outlet trips
Water from door
-
abrasive cleaning. Use alcohol to remove stubborn stains.
switches, water supply lines, drain pipes for possible damage. Replace as needed.
Cause
1.
The fuse is tripped due to short circuit
or overload
2.
Control system malfunction
1.
Pump inlet may be blocked
2.
Water Pump bearing may be cracked
3.
Pump overloaded
Short circuit or other electrical issues
The door seal is cracked or torn
Solution
1.
Check the circuit and reset (or replace
fuse if needed)
2.
Contact supplier
1.
Switch o power to stop the operation,
replace pump if needed
2.
Contact supplier
Check the circuit . Replace or repair
defective part
Replace the seal
7 |
P a g e
Rev 05/201 5