- ページ 6

録音機器 Dangerous Music MasterのPDF セットアップおよび操作マニュアルをオンラインで閲覧またはダウンロードできます。Dangerous Music Master 8 ページ。
Dangerous Music Master にも：ユーザーマニュアル (16 ページ)

Internal Jumpers and Adjustments (please see step 5 on page 2)

The motherboard has input cable shield ground selection jumpers to accommodate

different grounding schemes. It is recommended that all electrical equipment in the studio

is properly grounded by making sure that power cables have 3 pins and that the third pin

is connected to ground. The use of 'ground lifts' to clear up a buzz problem is frowned

upon by the international consortium of electrical safety agencies. If a ground noise

problem occurs, it may be cleared up by switching the jumper position on the connector

associated with the piece of gear that is having the buzz problem.

The shield lift headers have 2 posts. A jumper placed over both posts connects the chassis

ground to the cable shield. To lift a shield, pull the jumper off of the posts. It is a good

idea to put the 'unused' jumpers on one of the posts to keep from losing the jumper.

Master should not need to be calibrated but in case it does, here is the procedure:

1. Obtain a calibrated oscillator and level measuring device. These should be lab

quality (HP, Tektronix, Neutrik, Audio Precision, etc.)

2. Place the Master on a clean, well lit table with a pad under it to prevent scratches.

3. Remove the top to expose the motherboard for calibration.

4. Hook up the power supply and turn on the unit.

5. Set all controls to unity gain with all Function and Insert switches out.

6. Set the oscillator for +4dBu and plug into Input 1. Feed both channels.

7. Activate 'Insert 1' and measure the level coming out of the 'Send 1' jacks.

8. Adjust P1 and P2 to measure +4dBu.

9. Deactivate 'Insert 1' and adjust P3 and P4 to read +4dBu at 'Main Output 1'.

10. Adjust P5 and P6 to measure +4dBu at the 'Monitor Output' jack.

11. Activate the 'OUT MON' function and adjust P7 and P8 to read +4dBu at the

Monitor Output jack.

12. Pull the right channel's input. Activate the 'S&M' function. Adjust the 'xtalk' pot

for minimum signal at the Right output. The signal should null below -70dBu.