- ページ 10

オーブン Daniela DAN6FGSのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Daniela DAN6FGS 20 ページ。

ページを印刷する

CLEANING AND MAINTENANCE

• Prior to any maintenance work or cleaning,

disconnect the appliance from the electricity

mains.

• Do not use a steam cleaner to clean this

appliance.

• Do not wash the parts if they are still hot

• Never use abrasive powders, pads or corrosive

spray products.

• Do not leave vinegar, coffee, milk, salty water

or the juice of lemon or tomato on the surface

for any length of time.

• Switch off the oven before removing the fan guard

for cleaning. Replace the guard after cleaning

EXTERIOR PARTS

All the parts of the oven exterior (stainless steel, side

panels, door glass) must be cleaned frequently with a

mild detergent and a little water and then dried with a

soft cloth.

Do not use rough or abrasive materials or sharp metal

scrapers to clean the oven glass doors as they could

scratch and cause the glass to break. On painted

or stainless steel surfaces, do not use aromatic or

aliphatic solvents to remove spots or label adhesive.

INTERIOR PARTS

The oven should be cleaned after each use to

remove cooking residuals like fats or sugar which,

burnt afterwards, can encrust or form permanent

stains and unpleasant smells.

The oven should always be cleaned when it is still

warm with soapy water, rinsed and dry properly on all

surfaces. Also wash any accessory used.

Do not spray or wash the electric heating

elements nor the thermostat with acid-based

detergents (check the information label on the

product you are using). The manufacturer cannot

be held responsible for any damages caused by

incorrect cleaning.

�

INSTRUCTIONS FOR THE USER

OVEN SEAL

The condition of the oven seal is vital for the correct

functioning and performance of the oven.

We recommend you:

• Clean it, avoiding abrasive tools or products.

• Check its condition occasionally.

In case the seal has stiffened or presents

damages, contact your nearest Service centre and

avoid using the oven until it has been repaired.

OVEN SIDEWALL GRIDS (fig. 5)

To allow for a better cleaning of the side grids, you can

extract them this way:

• Push with a finger on the support bar to release the

grid from its hold (A).

• Lift it towards the top and extract the grid.

To put them back into place, reverse the order of this

operation.

REPLACING THE OVEN LAMP (fig. 6)

Ensure the appliance is switched off before

replacing the lamp to avoid the possibility of

electric shock..

In the event the oven lamp need replacing, the lamp

must comply with the following requisites:

15 W - 230 V~ - 50 Hz - E 14 - and must be resistant

to high temperature (300°C).

Lampholder (fig. 6):

• Extract the side grids as indicated in the previous

paragraph.

• Unscrew glass protection cap (V) from bulb holder

by lifting it with a screwdriver (C) against the inside

wall of the oven.

• Substitute the bulb and reposition all elements back

by following the operation in reverse order.

�