- ページ 6
録音機器 Brainworx Fuchs Overdrive SupremeのPDF プラグインマニュアルをオンラインで閲覧またはダウンロードできます。Brainworx Fuchs Overdrive Supreme 10 ページ。
ページを印刷するF X R A C K D y n a m i c s
NOISE GATE:
'CLOSED' LED:
When lit this LED indicates that the Noise
Gate is CLOSED. This means the THRESHOLD setting is
higher than the incoming signal and the noise gate dims
the output signal of the amplifier by the amount adjusted
with the RANGE control (e.g. 15dB in the picture above).
NOISE GATE ON/OFF:
On/off switch. Enable or disable the
Noise Gate completely. Switch up ('on') means the Noise
Gate is activated.
THRESHOLD:
Continuous knob, -120db to 0db. The Noise
Gate will dim the output signal of the amplifier as soon as
the input signal (your guitar signal) falls below a certain
level. This level is called Threshold. Adjust the Threshold
so the noise of the overdriven amp will be reduced, but
make sure you don´t cut fading notes or chords.
RANGE:
Continuous knob, 0db to 100db. The output level
of your amplifier will be reduced or muted when the input
signal is lower than the Threshold setting. You may dim
the output level only by a few decibels (dB), or completely
mute the output in pauses by setting the RANGE to its
maximum.
Fuchs Overdrive Supreme
|
AMP FILTERS:
(switchable pre/post)
TIGHT FILTER:
Discrete 3 steps: "Pre," "Post," and "Off."
With the TIGHT filter you can cut LOW frequencies of
either the DI guitar signal (PRE) or the processed amp
output (POST).
PRE:
If your pickups produce an unintentional rumbling bass
sound you can filter the low end before the DI sound even
hits the amplifier.
POST:
If you want to cut some of the low end of your
amplifier setting (maybe even only temporary) you can use
this studio quality high pass filter to reduce the bass.
OFF:
When set to OFF the TIGHT filter is in bypass mode.
TIGHT FREQUENCY:
Continuous knob, 30Hz to 3kHz.
Set the frequency below which low frequencies will be cut.
SMOOTH FILTER:
Discrete 3 steps: "Pre," "Post," and "Off."
With the SMOOTH filter you can cut HIGH frequencies
of either the DI guitar signal (PRE) or the processed amp
output (POST).
PRE:
If your pickups catch a lot of hiss or noise you can filter
the high end before the DI sound even hits the amplifier.
POST:
If you want to cut some of the high end of your
amplifier setting (maybe even only temporary) you can use
this studio quality low pass filter.
OFF:
When set to OFF the SMOOTH filter is in bypass mode.
SMOOTH FREQUENCY:
Continuous knob, 3kHz to 35kHz.
Set the frequency above which high frequencies will be cut.
6