- ページ 5

自動車アクセサリー BrakeBuddy STEALTH 39530のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。BrakeBuddy STEALTH 39530 9 ページ。

STEP 2: PoSITIoN mAIN UNIT (A)

1. Take main unit and position in the most convenient, out of sight place in the towed vehicle. Below are some

suggested mounting locations.

UNdER THE SEAT

2. Ensure there is an optimal way to route the cable from the main unit to the brake pedal. A 90° bend is allowable with

minimum radius of 6 inches.

3. Route cable to brake pedal. Allow enough cable to be able to hide under thresholds and floor mats. DO NOT attach

the main unit at this time or cut cable to length.

STEP 3: moUNTING loCATIoN foR PUllEy ANd BRAKE PEdAl ClAmP (B)

1. Position brake pedal clamp above the brake pedal as shown

in (Figure 1). The brake pedal clamp is attached with bolts in

the pre-drilled holes on the brake pedal clamp. Ensure bolts

are placed as close to the brake pedal arm on each side.

STEP 4: moUNT PUllEy To flooR BEHINd BRAKE PEdAl (B)

1. Position pulley with large hole downward as shown in (Figure 1).

Ensure the pulley is directly in-line with the hole in the angle on

the brake pedal clamp as shown in (Figure 2).

2. Mount pulley to floor of towed vehicle with the 4, 1.5" self

tapping screws provided.

Make sure the exit side of the screws will not damage

components on the other side of the firewall.

Verify the brake pedal clamp does not interfere with the total

downward movement of the braking action.

311-0288-281 Rev. A 2/13

IN THE TRUNK

NoTE

WARNING

NOTE

May want to check with RV'er to see

where they would like it placed.

WARNING

Main Unit is not designed to be installed outside the

towed vehicle or within the engine area

Figure 1

Figure 2

1-800-470-2287