- ページ 5
留守番電話 AUDIOLINE TAM-838のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AUDIOLINE TAM-838 12 ページ。
ページを印刷するSETUP
OUTGOING MESSAGE (OGM)
The system has a built in announcement message. "Hello please leave a message after
the tone". You can use this message or record your own.
To record your own announcement message:
# Ensure the machine is switched on.
# Press and hold the
# After a beep tone record your message (maximum: 30 seconds).
# When finished, release
# Repeat procedure if you wish to change your announcement message. To revert
back to the pre-recorded announcement, press the
playback of your announcement.
SETTING THE CLOCK
# Press and hold
# Press and release the
will show 01 = Monday 02 = Tuesday etc, then;
# Press and release the
will show the hour 01, 02 etc and announce am/pm, then;
# Press and release the
minute (press and hold to advance by 10 minute steps).
# Release the
[TIME SET/CHECK]
# If you make a mistake, repeat the above procedure.
# To check the settings, press and release the
set time' is announced, the time has not been set.
NOTE: If you do not set the time, the system will not announce the time each
message was received.
ANSWERING CALLS
The switch 2/7/TS at the side of the system determines how the system answers calls.
2 = the system will answer a call after 2 rings
7 = the system will answer a call after 7 rings
T/S = the system will answer a call after 2 rings if new messages are recorded and
after 4 rings if no new message exists.
[ANNC/DAY]
button, display shows "A1".
[ANNC/DAY]
[TIME SET/CHECK]
[ANNC/DAY]
[2WAY/HOUR]
[MIN]
button to set the minutes. The display will show the
button. The unit will announce the time set.
AUDIOLINE TAM838
button, your greeting will now replay.
[DELETE]
button you will hear a beep, at the same time;
button repeatedly to set the day. The display
button repeatedly to set the hour. The display
[TIME SET/CHECK]
button during
button. If 'Please
3