- ページ 9

電源 Danish Interpretation Systems DCS 6000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Danish Interpretation Systems DCS 6000 14 ページ。 Digital conference system
Danish Interpretation Systems DCS 6000 にも：ユーザーマニュアル (19 ページ), ユーザーマニュアル (10 ページ), ユーザーマニュアル (14 ページ), ユーザーマニュアル (13 ページ), ユーザーマニュアル (18 ページ), ユーザーマニュアル (14 ページ)

Danish Interpretation Systems

System settings

The output channels are each set by use on the DIP

Switch and the Rotary Switch as shown in the

following figures.

The channel setting are normally done that the first

channel (A) is set to CH 0 (original) the next (B) to

CH1 and so on.

Setting CH 0 to CH 13

For using CH 0 to CH 13 set the DIP switch as

shown in the figure.

For each of the 8 channels set the wanted Channel

Number by turning the Rotary Switch to the wanted

channel. The numbers on the Rotary switch

corresponds to a Channel Number as show in the

figure below.

If a channel is not in use set the DIP switch for that

channel to OFF.

Important: No channels on any IT 6108 in the

system must be set to the same Channel Number

Manual 01 18 04452, Printed in Denmark, 02/2003 CHN

Important: Do not set the rotary switch to

position B at any of the rotary switches where

the DIP switch is set for "channel 0 to 13", as it

will make the transmitter not working

Setting CH 14 to CH 29

For using CH 14 to CH 29 set the DIP switch as