- ページ 12
ラミネーター Caslon Maxit 927のPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Caslon Maxit 927 13 ページ。
Caslon Maxit 927 にも： 操作およびメンテナンスマニュアル (12 ページ)
ページを印刷するSmall misses in the adhesive coating on the back or some streaky areas in the coating.
The Maxit is running too hot. When running too hot the adhesive is less tacky so the
paper does not hug the roller well and does not pick up the proper amount of adhesive.
Running too hot also thins out the adhesive on the coating roller.
Turn the temperature down slightly to the left. If the knob is at the 12:00 position,
turn it to 11:00 and wait 30 minutes for the temperature to reset.
Receive a thin straight line of missed adhesive in the direction in which you are coating
the paper.
There is dirt or debris lodged between the wiper blade and coating roller and is blocking
the adhesive flow.
Loosen the screws on top of the wiper blade and use the two set screws in front of
the blade to bring the blade back, away from the roller. Clean out any dirt in the blade area. If
the blade is very dirty, you may want to remove it to clean it.
The paper comes out of the machine with "score" lines on the image side.
The paper is too thin, so it hugs the coating roller then goes over the stripper fingers
which marks it with lines.
Use heavier gsm paper. The minimum recommended weight is120gsm. With photo
paper minimum is 9 mils. If the paper is borderline, then you may be able to eliminate the lines
by increasing the temperature and thinning out the coating using the wiper blade.
Coating is too thick or too thin
Position of wiper blade
Reset the blade using the instructions on Page 7of this operating guide.
Getting drops of adhesive on the leading edge of the paper.
Adhesive is building up on the leading edge of the stripper fingers after running the
motor for a while.
Turn off the motor for a minute and the drops should melt away. Also space the
fingers so there is the minimum amount needed under the paper. Reset the blade to produce a
thinner coating.
Page 11