- ページ 4

アンプ Audionet AMP IIIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Audionet AMP III 11 ページ。 Three channel power amplifier
Audionet AMP III にも：ユーザーマニュアル (16 ページ)

ページを印刷する

Inputs and Outputs

For adding or removing connections your AMP III must be

switched off!

Please make sure that all cables are in absolute best condition. Bro-

ken shields or short-cut loudspeaker cables could damage loud-

speakers or the amplifier!

Inputs

At first connect your AMP III to your preamplifier. Normally, the inputs

labeled "direct in" should be used for this purpose.

Additionally, the AMP III is equipped with an AC-coupled input.

Using this input removes a DC-offset (direct current) from the signal of

the preamplifier by a high-grade capacitor.

You should use this "ac-coupled in" only, if you have problems with

D.C., which are not unlikely especially with active crossovers. By con-

necting the source to these inputs you prevent a DC-current flowing

through the loudspeaker woofers decreasing sound dynamic and quality.

In extreme cases the AMP III might even shut down showing the "DC"

flash code (see below).

Loop output

The Audionet AMP III can be connected to other power amplifiers for

"multi"-amping. For this purpose the signals from the input are routed

back to the output labeled "out".

Speakers

Connect the left and right speakers to the gold plated WBT terminals on

the rear. Please make sure that the red outputs (+) of the amplifier are

connected to the positive inputs of the loudspeakers (usually red) and the

white outputs (-) are connected to the negative loudspeaker inputs (usu-

ally white or black).