- ページ 8

アンプ audiophony Combo 240のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。audiophony Combo 240 13 ページ。

ENGLISH

7 - Preparation and installation

7.1 - Installation within 19" racks

First of all, get the two mounting brackets and the 6 supplied screws ready. You should also get a Phillips

screwdriver to perform this procedure.

• Place one of the fin to the right front edge of the chassis. The part with two holes must be oriented toward

the front of the unit.

• Insert a screw in each hole of the bracket and tighten it as much as possible.

• Repeat the same process for the second bracket.

• Use the screwdriver to remove the 4 rubber feet of the unit.

When mouting your device into a rack, please make sure not to block the cooling vents.

Please check regularly the tightening of the screws to ensure a safe positioning of your device.

7.2 - Installing an optional module (MOD1)

Follow the steps described below to add an optional module to your COMBO240:

• Remove the 5 screws tightening the top cover (four on the sides and one at the rear).

• Remove the front panel by removing the 4 screws.

• Insert the module in the free space, please make sure not to pinch any cable.

• Connect the black cable (2 threads) to the AM terminal located at the rear of the unit (inside)

• Connect the black cable (1 thread) to the FM terminal located at the rear of the unit (inside)

• Connect the Power+Audio cable (6 threads) supplied with the module to the support of the module

provided for the purpose.

• Fix the module to the side metal plate with the supplied screw.

• Fix the module to the façade with the 4 screws provided for the purpose.

COMBO240 - Multi-zone mixer/amplifier