- ページ 3

TVマウント aevit 2.0のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。aevit 2.0 17 ページ。 Mounting brackets

ページを印刷する

1. INTrOdUCTION

1.1 OVErVIEw

EMC provides many different options for mounting the AEVIT 2.0 devices.

These devices include the AEVIT 2.0 Primary Input Devices, the AEVIT 2.0

Display, and secondary switch options. This manual will show the recom-

mended mounting options for all of these devices. Also provided in this

manual are a few variations of the recommended mounting options that

may better suit your client.

This installation manual is broken down into two (2) major sections. The

first section focuses on the Primary Input Mounting Brackets. This section

will show how to install brackets for mounting Steering and Gas/Brake

input devices. The second section will focus on Secondary Input Mounting

Brackets. This section deals with the mounting of the AEVIT 2.0 Display and

secondary activation switches.

1.2 INSTALLINg ThE MOUNTINg BALL ONTO INpUT dEVICES

All EMC mounting options provide versatility with the use of ball-and-socket mounting brackets. Mounting Balls will

need to be attached to the input devices and the corresponding mounting brackets will have the mating sockets.

Therefore, the first step in installing any of the input devices is to install the mounting ball to the bottom of them.

Each Input Device Install Kit should have a Mounting Ball and a Mounting Ball hardware kit that contains the follow-

ing:

(4) 10-32 x 1/2" Safety Torx Screws

(4) #10 Internal Tooth Lock Washers

Install the Mounting Ball onto the input device using (3) 10-32 x 1/2" safety torx screws, (3) internal tooth lock washers

and the Blue Loctite® as shown in Figure 1. In order to install the (3) safety torx screws you will need to use the sup-

plied safety torx bit. There are (7) pre-drilled holes on the mounting ball. Figure 2 shows which holes should be used

to mount the ball onto the input device.

ALL AEVIT 2.0 PRIMARy INPUT DEVICES AND ThE AEVIT 2.0 DISPLAy ARE DESIGNED TO hAVE ThE SAME

MOUNTING BALL SCREW PATTERN. ThEREFORE, ThIS INSTALLATION STEP ShOULD BE PERFORMED FOR

INPuT

DEvICE

MOuNTING

BALL

INTERNAL TOOTH

LOCk wASHERS

10-32x1/2"

SCREwS

ALL INPUT DEVICES (LEVER, WhEEL, jOySTICK...) AND ThE AEVIT 2.0 DISPLAy.

use Blue

loctite®

FIGuRE 1

BE SURE TO PROPERLy TIGhTEN ThE SCREWS TO ThE PROPER TORqUE

SETTING OF 2.0 FT-LBS AND USE BLUE LOCTITE

(1) Safety Torx Bit

(1) Container of Blue Loctite®

NOTE:

INPuT

DEvICE

(uNDERsIDE)

WARNING:

AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL

Mounting Brackets

use these (3)

MOuNTING

Mounting

BALL

holes

FIGuRE 2