- ページ 5
サブウーファー audiophony GOA MTsub12AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。audiophony GOA MTsub12A 8 ページ。
ページを印刷するMTsub12A - Amplified subwoofer - 12" - 400W RMS
1
Power input socket
Connect here the supplied power cord.
Please only use this power cord or an equivalent one.
2
Power button
Please turn the LEVEL knob to 0 before activating your
subwoofer.
3
BALANCED INPUTS
Balanced female XLR inputs.
Connect here your mixing desk or any other line-level
source.
4
UNBALANCED INPUTS
Unbalanced female RCA inputs.
Connect here your mixing desk or any other line-level
source.
When using long runs of cables, please use the balanced
inputs aforementioned in order to avoid parasitic noises.
5
PHASE
Phase inverter switch.
The phase inversion is especially useful when using
several subwoofers simultaneously.
Depending on the position of your subwoofers, low
frequencies might cancel each other. use the phase
inverter to fix this.
4 - Technical specifications
• Total power output: 400 W RMS / 800 W Max
• Switched-mode power supply unit
• Frequency response: 50 Hz to 180 Hz
• Sound Pressure Level: 124 dB max
• Woofer: 12", 4 Ohms, 400 W RMS
• 1 Line-level stereo input via XLR and RCA
• 1 Line-level stereo input via XLR
• Volume settings
• Subwoofer cutoff frequency: 80 to 180 Hz
• Low-pass filter (OFF-80-125) for satellites output
• Phase correction: 0-180°
• Protections: SC, thermal and limiter
• Cubic plywood housing with bass reflex and integral grille
• 2 side handles
• 36mm mounting plate for stands (on top)
• Dimensions: 469 x 489 x 360 mm
• Net weight: 21,6 kg
6
XOVER
Cutoff frequency control knob.
Use this knob to adapt the cutoff frequency of your
subwoofer to your broadband speakers.
7
LEVEL
Allows you to adjust level output of your subwoofer.
This can be set at maximum, however make sure not
to exceed a 0dB volume output via your mixing desk to
ensure optimal sound quality.
8
SAT LOW CUT
Allows you to adjust the cutoff frequency of "BALANCED
OUTPUTS".
Position it onto 80Hz or 125Hz if you need your
subwoofer only to amplify low frequencies.
9
BALANCED OUTPUTS
Balanced male XLR outputs.
Use these outputs to send the incoming signal to your
satellites.
Signals going through these outputs are not amplified
nor affected by the LEVEL control knob.
Activate the SAT LOW CUT function for the signal to be
filtered at the selected frequency (80Hz or 125Hz).
English
Page 5