- ページ 17

計測機器 Consonics CyberTek QualifierのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Consonics CyberTek Qualifier 19 ページ。

Receiver Block Diagram

Test Signal

Connection

The precision receiver is powered by an internal battery and is portable in design.

A test sequence consists of the following steps.

Receiver is connected to ground block of residence under test.

User interface powers on the activate encoder. The activate encoder has been previously

setup to match the intended vehicle transmitter. The activate transmitter is powered on and

the activate signal is radiated from the internal antenna.

The vehicle transmitter receives the activation signal and verifies the coding. If the coding

matches, the vehicle transmitter powers on and radiates the residence with the test signal.

The input tuner section receives the test signal resulting from ingress into the residence. The

test signal detector qualifies the test signal as originating from the test transmitter. If the test

signal qualifies, the display converter sends the level measurements to the visual display. If

the receiver is configured as such, a Pass / Fail message is displayed.

Measurement data is stored to data memory by the user interface.

Internal Activate Antenna

Activate

Transmitter

Input Tuner

Section

User

Interface

Activate

Battery

Encoder

Test Signal

Display

Detector

Converter

Data

Memory

Display

Qualifier Supplement

Power

Visual