- ページ 4

スピーカー Audiopipe DJAP-612PBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Audiopipe DJAP-612PB 16 ページ。 Djap series hybrid portable pa system

1. Introduction

Thank you for purchasing the DJAP 2-way vented powered speaker system. This unique system was designed to be an all-in

one portable solution with built-in High Power amplifier, 4 channels mixer with 3-band EQ and 24-bit DSP effects. The DJAP

combines practicality with top design concepts achieved over many years of manufacturing quality products. Please read this

manual carefully so you can take advantages of all the features of the DJAP.

Portable plywood painted cabinet with wheel

1 x 12" (DJAP-612PB) /1 x 15"(DJAP-615P)woofer and 1 x 1" throat compression driver

4 channels mixer with a total of 4 inputs, Balanced XLR & TRS inputs

7-band graphic EQ

Ultra low noise discrete MIC pre-amps with +15V phantom power

3-band EQ on all input channels

Independent level controls on each channel

High headroom for excellent dynamic range

On-stage monitor mix

DSP/FX send for built-in or external effects

Tape In/Out

24-bit DSP effects with 100 presets

USB-MP3 function

Mini plug input for portable players with level control

3.1 MIXER SECTION

1. MONO INPUT Channels

CH1 through CH4, come with balanced MIC IN and LINE INconnectors. Use the XLR (MIC IN) socket to connect a

lowimpedance microphone or low level signal, which also features+15V phantom

power allowing you to connect a condensermicrophone.Use the 1/4" TRS (LINE IN)

jack to connect either a microphone or aline level instrument such as synthesizers,drum

machines, effect processors or any other line level signal.

Note: You shall never connect an unbalanced microphone to XLR socket if you do not

want to damage both the microphone andunit.

2. +15V PHANTOM POWER Switch

This switch will apply +15 Volt phantom power only to the 4 XLRinput sockets. When

these XLR sockets are connected with devices that do not require phantom power, please

make sure the phantom power is turned off, otherwise, this may damage thedevice and

monitor.

3. Channel LEVEL Control

This control isused to adjust the overall level of volume for respective channel. The

adjustable range goes from -

4. DSP/FX AUX1 POST Control

This control is configured as a POST-FADER, so the audio signalwill be affected by the

channel level control. Via the FX SEND jack,the AUX1 signal can be sent to an external

to +10dB.

DJAP-61PB DJAP-615P