- ページ 6

コントローラー Dantel 41095のPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Dantel 41095 12 ページ。 Order wire control and speaker monitor panels

INSTALLATION

nstallation consists of wiring a jumper for modular cords,

connecting the speaker leads, connecting power, connecting

signaling leads, and wiring to the DTSS3A order wire terminal.

1. Wire the Modular Cords Jumper.

Refer to Fig. 4. A board behind the panel provides modular-type

telephone jacks, labeled J1 through J12. Each order wire tele-

phone jack connects to one of the jacks (J1-J12) using a six-lead

extension phone cord. These jacks carry the four-wire signal

leads and the lamp leads.

When you use the modular cords, you must install a jumper on

each order wire terminal from pin P3-1 to pin P1-5 and from pin

P3-2 to pin P1-7.

Use wire-wrap terminal blocks (TB2 and TB3) when you do not

use modular-type cords.

2. Connect Speaker Leads.

Refer to Fig. 4 and Fig. 6. Separate wire-wrap terminals (J101,

J107 and J108) are available to hook up the speaker lines from

the DTSS3A terminals.

3. Connect Power.

Refer to Fig. 4. Power (-21 to -56 VDC) connects at screw termi-

nal strip TB1.

4. Connect Signaling Leads.

For a six-circuit 41095 Panel (41095-10) connect signaling leads

from any of the pins at TB2-9 (A-E) or TB2-10 (A-E) to pin P1-1

on each order wire terminal. Jumper pins P1-2 to P1-6 on each

order wire. Refer to Table A and Fig. 5.

5. Wire to the DTSS3A terminal.

Wire the 41095 Panel to the DTSS3A with modular cords or

wire-wrap connections. Refer to Fig. 6.

41095-0898 <90-00129>

AGE