コントロールユニット Audioplex CSVC1550のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Audioplex CSVC1550 2 ページ。 Stereo volume control

Attenuator type:

Switch:

Connector:

Input Power Rating:

Mounting:

Installation must be made by qualified service personnel, and must meet all local codes.

Before starting connections, please note that the left and right attenuator circuits are completely isolated

from each other to prevent instability when used with certain types of amplifiers which have floating

grounds. If the amplifier to be used has common grounds between channels, a 3 wire system can be used

between amplifier and control, but it will be necessary to connect a jumper between the control ground

returns (L- & R-). If one ground is open, there will be no output on the ungrounded channel at any

attenuator setting.

1. Make connections by stripping wire insulation back about 3/16". Twist any loose strands tightly.

2. Insert the wires from the amplifier into the INPUT openings of the connector, hot to hot and ground

to ground, then tighten screws. Check for stray wire strands that might cause a short circuit. Make

sure the metal part of the screw connector engages the bare wire, NOT the insulation!

3. Similarly, connect speaker wires to the control OUTPUT openings and tighten screws.

4. Install control in its operating location. Suggestion: Leave control 3 or 4 positions CCW from

maximum before firing-up the system for the first time to avoid "blasting" the speakers, while still

having enough sound to observe operation.

INSTALLATION MANUAL

TECHNOLOGY

CSVC150 STEREO VOLUME CONTROL

SPECIFICATIONS

Tapped auto transformer

12 position rotary, make-before-break contacts

Screw-tight type, non-removable

Complies with UL 1492 @50 Watts RMS continuous, 150 Watts audio

Fits most standard gang electrical junction boxes

INSTALLATION

2010 - 9/16/2010