- ページ 2
ガレージドアオープナー BelFox Fabia50-ZのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。BelFox Fabia50-Z 14 ページ。
ページを印刷するD Inhaltsverzeichnis
1.
2.
3.
4.
5.
6.
7.
8.
9.
Sturzwinkel befestigen
14. Einstellung der Motorsteuerung
15. Einlernen der Funkcodierung
16. Löschen aller Funkbefehle
17. Teilöffnung
18. Änderung Sanftauslauf
19. Automatische Schließung
20. Langsame Geschwindigkeit
21. Gezielte Ansteuerung AUF oder ZU
22. Totmannbetrieb
23. Automatische Beleuchtung
24. Anschluss Lichtschranke
25. Anschluss Sicherheitskontaktleisten
26. Warnlicht, Vorwarnfunktion
27. Schlupftürsicherung
28. Taster / Schlüsselschalteranschluss
29. Haubenbesfestigung
30. Notentriegelung
31. Löschen des Laufweges und der Kraft
32. Sicherheitsabschaltung
33. Fehlersuche
GB table of contents
Technical data
EC-Directives and norms
Scope of delivery
Preparation of the door
Removal of locking
Measuring the middle of the garage door
Determination of the top point
Assembly of the operator (if not pre-
assembled)
Fitting lintel angle
Fitting the operator on lintel angle
Fitting the operating head
Fitting the door mounting
Adjustment of the limit switches
Adjustment of the motor control
Memorizing radio codification
Clearing all radio codifications
Partial Opening
Modification of soft stop
Automatic Closing
Slow movement
Direct impulse to open or close the door
Dead man´s handle
Automatic Light
Connection of light barrier
Connection of safety contact ledge
Warning signal, prior warning function
Access door protection
Connection of push-button / key switch
Fixing the cover
Emergency release
Clearing memorized course and power
consumotion value
Switching off in case emergency
Recognizing and remedying faults
1
33. GB Recognizing and remedying faults
Probable fault
system does not respond power failure
activation
is
possible
battery of transmitter weak
with touch button or key
or dead,
switch, but not with
radio transmitter faulty,
radio transmitter
radio receiver faulty
no codification memorized,
antenna
correctly
short range of radio
battery of transmitter weak,
transmitter
abnormal radio inteference,
position of antenna not
optimal
door does not fully open
power consumption value
or close
too low,
adjustment
switches incorrect,
door faulty
door
stops
running
safety automatism activated remove obstacle and give
without
reaching
the
limit
switches
or
reverses
operator only runs with
operator has memorized
soft speed
course incorrectly
Remedy
check mains supply, check
fuse on control board
replace battery,
check
with
the
transmitters,
then
transmitter or control board
for repair
memorize
codification
(never
set
all
encoding
switches just to „ON" or
„OFF")
not
installed
install antenna correctly
(clamps 27)
replace battery,
check optimal fitting of
antenna by trying different
positions
check receiver with other
transmitters, if then the range
is
much
better,
transmitter for repair
readjust power value (max.
15 kg additionally to the
power consumption of the
door´s movement),
of
limit
readjust limit switches,
consult your door supplier
impulse anew, possibly you
may
have
to
memorize
power value anew
Clearing memory
(page 23)
26
other
return
return