- ページ 5

洗濯機 CONSTRUCTA Washing machineのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CONSTRUCTA Washing machine 6 ページ。 Front-loading washing machine
CONSTRUCTA Washing machine にも：取付説明書 (6 ページ)

ページを印刷する

Levelling

Intense noise, vibrations and "wandering" may be the result of incorrect levelling.

Levelling the washing machine with a spirit level

1. Loosen the lock nut using a spanner, by turning it in a clockwise

direction.

2. Change the height by turning the appliance feet.

Caution: all four appliance feet must be firmly on the ground.

The washing machine must not wobble.

Check the levelness of the washing machine with a spirit level and adjust

if necessary.

3. Tighten the lock nut against the housing.

In doing so, hold the foot tight and do not adjust its height.

Caution: the lock nuts on all four appliance feet must be screwed tightly

against the housing.

Electrical connection

The washing machine must only be connected to an alternating current via a

properly installed earthed socket.

The power supply and voltage indicated on the washing machine (rating plate)

must be the same.

The connected load and fuse required are specified on the rating plate.

Make sure that:

– the mains plug fits the socket,

– the cable cross-section is adequate,

– the earthing system is properly installed.

The mains cable may only be replaced by a qualified electrician (if required).

Replacement mains cables are available from customer services.

Do not use multiple plugs/couplings or extension cables.

If a residual current circuit breaker is used, only use a type which displays this

symbol: ‚.

Only this symbol guarantees compliance with the currently applicable regulations.

Mains plug:

– do not plug in to/pull out of the socket with damp hands.

– when removing the plug from the socket, pull the plug body only, not the cable.

– never pull the plug out during operation.

Manufacturer -> Instruction manual

Transportation, e.g. when moving house

Before transporting the washing machine:

1. Turn off the tap.

2. Drain residual detergent solution > Instruction manual; Maintenance - drain pump.

3. Reduce the water pressure in the inlet hose > Instruction manual; Maintenance - filter in

water inlet.

4. Disconnect the washing machine from the power supply.

5. Disconnect the hoses.

Install the transport safety devices:

1. Remove the covers.

2. Insert all 4 sleeves.

Clamp the mains cable to the holders. Insert and

tighten the screws.

After transportation, the transport safety devices must be removed. > Page 3.

To prevent unused detergent from flowing straight into the drain during the next wash:

Pour 1 litre of water into compartment II and start the Empty programme.

Technical specifications

Dimensions (width x depth x height)

Weight

Mains connection

Water pressure

60 x 59 x 85 cm

63 - 83 kg depending on model

Nominal voltage 220-240 V, 50 Hz

Nominal current 10 A

Nominal power 2,300 W

100-1000 kPa (1-10 bar)