- ページ 12

防犯カメラ 3xLogic VX-4V28-MD-IAWのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。3xLogic VX-4V28-MD-IAW 15 ページ。 Visix v-series all-in-one camera – gen ii

ページを印刷する

6. Ensure that the camera is configured with the proper time zone, auto daylight savings update and set

for NTP (auto time sync).

7. The cameras live view will be displayed in the app for final positioning.

8. Setup results can be emailed upon completion for easy monitoring configuration.

Note:

The V-Series camera will automatically check for updates and format the SD card. Please allow

15 minutes before power cycling the camera.

Camera Setup - Non-DHCP Networks

The 3xLOGIC All-in-One PC Setup software was engineered specifically for use in non-DHCP networks where

the mobile app (requires DHCP) cannot be used to configure the camera. A laptop connected to the same

network as the camera will be required to discover the camera and assign a valid IP address using the 3xLOGIC

All-in-One PC Setup.

1. Download

and

http://www.3xlogic.com/support-center/software

2. Confirm the PC is networked with the cameras then launch the utility. If properly networked, the utility

will automatically detect cameras on the network (click Refresh to refresh the list).

3. Select the desired device from the list of available cameras.

4. Click IP Setup and assign the desired IP.

5. Fill out installer and company information.

6. To activate the camera, you will be required to assign a complex password.

7. Confirm the camera Live View preview is as desired and click Continue.

8. Adjust any/all camera settings including the camera name and VIGIL Connect alias. Be sure to remember

the VIGIL Connect Alias as well as the username and password you assign to the camera. These

credentials will be required to add the camera to other VIGIL utilities.

9. Fill out remaining information and complete steps in the setup tool to receive an installation summary

e-mail.

Note:

The V-Series camera will automatically check for updates and format the SD card. Please allow

15 minutes before power cycling the camera.

Remote Monitoring and Viewing - Adding a V-Series Camera to VIGIL Client

Steps:

To interface a V-Series Camera with VIGIL Client:

1. Launch VIGIL Client (Local Mode only; VCM mode will only display Servers from a networked VCM Server)

and select Servers from the Servers top menu. This will launch the Servers window. VISIX V-Series

devices are considered edge recording devices and thus are recognized as their own VIGIL Server within

the VIGIL suite.

2. Click Add. This will deploy the Add/Edit VIGIL Server window.

3. Enable the Use VIGIL Connect option. If connecting using traditional network connection criteria is

desired, enter the cameras IP Address/DNS Name and confirm TCP/IP port status.

4. Enter in the VIGIL Connect alias of the desired V-Series Camera (VIGILTest1 used in the below example).

Skip this step if using traditional network connection criteria (IP/Port).

5. Click Test VIGIL Connect to confirm the camera can be communicated with through the Connect system

using the provided alias. Skip this step if using traditional network connection criteria (IP/Port).

10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC

install

the

3xLOGIC

All-in-One

V-Series Camera Quick Start Guide | VX-4V28-MD-IAW

Setup

Utility

for

Windows

from: