ページを印刷するWe recommend removing the ash produced every day. Never allow the ash to accumulate to the point
where it touches the grate; this would obstruct the circulation of primary air and slowly suffocate the fire.
When cleaning the outside surfaces of the stove, avoid abrasive products which would damage the
protective paint. Do not use chemicals that contain diluent, because the cast parts are protected by heat
resistant paint.
Panoramic door glass should be cleaned with normal detergent and exclusively after getting cold. After
cleaning, rinse with pure water and dry. To clean the parts in tiles use non -abrasive detergents, water and
a soft cloth which do not damage the glaze.
7. CONSUMABLES
The following are considered consumables and therefore not covered by the warranty:
all gaskets, the parts in ceramic hardened glass, the facing of the hearth, the paints, the ceramics and the
parts with chemical coating (chrome, nickel, zinc parts). The warranty does not cover damages caused by
improper installation, incorrect connection not in compliance with the instructions which accompany the
product, or breakdowns caused by tempering from unqualified or unauthorized personnel.
8. SUMMER PAUSE AND RECCOMENDATIONS FOR THE SEASON
After you have cleaned the hearth, the chimney and flue, trying to eliminate completely the ash and
other residuals, you must close the hearth door and its regulators; in case that you are disconnecting the
device from the flue, you must close its openings in order to enable operation of other devices connected to
the same flue.
The cleaning of the flue should be done at least once a year. Check the state of gaskets and replace
them if necessary.
If there is dampness in the room where the stove has been placed, we advise you to put absorbent
salts into the hearth. If you want to keep for long the aesthetic look of the stove it is important to protect its
internal walls in cast iron with neutral Vaseline.
9. SOLUTIONS OF THE PROBLEMS
9.1 The appliance does not work
Check that the entrance of the chimney has been carried out perfectly.
Check whether the dimensions of the chimney are correct and appropriate to the appliance.
Check whether the flue is well isolated from thermo agents and made according to the standards.
The doors of the stove must be well sealed.
9.2 Difficulty in lighting the fire
Open the primary air and the smoke register.
Use very dry wood.
Air the room in order to have a great quantity of oxygen.