ページを印刷するminutes.
Refuelling Procedure
Always refuel onto hot embers.if there is insufficient burning material in the firebed to
light a new fuel charge,excessive smoke emission can occur.Refuelling must be
carried out onto a suffcient quantity of glowing embers and ash that the new fuel
charge will ignite in a reasonable period. If there are too few embers in the fire
bed,add suitable kindling to prevent excessive smoke
WARNING:
Directly after re-fuelling, It was necessary to operate with the door ajar for a
period of 3 minutes in order to maintain flames on the new re-fuel charge.
Do not leave the fire unattended until the flames are well established on the newly
charged logs
It is important to follow these instructions in order to achieve clean burning and to
maximise the efficiency of the stove.
The stove must not be overloaded with fuel.
smoke,Following the above procedure will maximise the performance of the
stove. Typically, the four logs will burn with an attractive flame pattern and will last
for about an hour (although this will depend on weather conditions, e.g. whether it is
windy, and specific installations, e.g. chimney dimensions)
WARNING:
If there is insufficient burning material in the fire bed to light a new fuel charge,
excessive smoke emission can occur. Refuelling must be carried out onto a
sufficient quantity of glowing embers and ash that the new fuel charge will ignite
in a reasonable period. If there are too few embers in the fire bed, add suitable
kindling to prevent excessive smoke
The maximum amount of fuel specified in this manual should not be exceeded,
overloading can cause excess smoke.
Operation with the door open can cause excess smoke. The appliance must not
be operated with the appliance door left open except as directed in the
instructions.
Operation with the air controls or dampers open can cause excess smoke. The
appliance must not be operated with air controls or dampers door left open
except as directed in the instructions
Overloading can cause excess
11