- ページ 2

録音機器 AudioSource EQ 11のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AudioSource EQ 11 6 ページ。 Ten-band stereo graphic equalizer with spectrum analyzer display

ページを印刷する
Left Channel
Bass
Model EQ Eleven
Model PRE TWO
+12
Graphic Equalizer and
Stereo Pre-Amplifier
Spectrum Analyzer
Phono
0
-12
30
60
Power
Hz
Power

Using The Controls

Power : Press this button to activate the power on the EQ Eleven.The Red LED will
light to show power is "On". Push the button again to turn "Off" the EQ Eleven. The
red LED will disappear at this time.
Power
EQ Rec. : EQ Record. Press this button to make a tape copy with the equalization
curve you have just set. This can be useful when making a cassette tape to play in
your car. A well-equalized tape can improve the sound from smaller, less expensive
EQ Rec
car stereo speakers. With this button in the "Off" position, the cassette tape copy will
be recorded without equalization.
Monitor: Press this button to hear the sound from your cassette deck. This cassette
deck should be connected into the "Tape In" and "Tape Out" jacks on the rear panel of
the EQ Eleven.
Monitor
Audio/Video : This button selects between two input sources. Press the Button "IN"
to select an Audio input source, such as a C.D. player. The red LED will light to show
this selection. Leave the button "OUT" to select a Video input source, such as a
V.C.R., or Lazerdisc player. The red LED will remain unlit to show this selection.
Audio
Note: the EQ Eleven equalizes the sound of these various components. At no time
Video
does the EQ Eleven alter the picture, and no "Video-Type" connections are included.
These inputs will accept any "Line Level" source, such as a CD player, tape deck,
laserdisc, VCR, etc.
EQ / Pass : Use this switch to instantly compare the "equalized" and unequalized"
sound. Press this button "IN" to hear the result of your equalization curve. The red
EQ
LED will light to show this selection. Leave this switch in the "OUT" position to
Pass
bypass the equalization of the EQ Eleven.
EQ Sliders : Each of these sliders will give 12Db. of "Boost" and 12 dB. of "Cut".
There are ten sliders per channel - Ten for the Left channel, and Ten for the Right
channel. Looking at the front panel, the sliders that control the lowest frequencies are
on the left, with the higher frequencies farther right. Usually, identical adjustments
should be made for both channels.
Mid
Treble
+12
0
-12
120
240
500
1
2
4
8
16
kHz
Monitor
Right Channel
Spectrum Analyzer
Bass
0
-12
30
60 120 240 500
1
2
4
8
16
30
Hz
Video
Tape 1-2
Line
EQ Rec
Pass
Tape 2-1
Audio
Tape
EQ
Mid
Treble
60
120
240
500
1
2
4
8
16
kHz
Level
L
R
+12
+12
+12
0
6
6
0
0
-12