- ページ 4
計測機器 Consumer Physics SCiO CupのPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Consumer Physics SCiO Cup 4 ページ。
ページを印刷する
Troubleshooting
Q: Several readings of the SCiO seem different than what I'd expect. What should I do?
A: Scan more - either more scans of the same sample or more samples from the same pile.
Q: I get a 'Material Not Recognized' error when scanning
A: Check the following:
1. Check that you are using the right applet for the material you are testing
2. Check that the dome and its surroundings are clean.
Q: I get a "Too Bright, Please rescan" error when scanning
A: Check the following:
1. Make sure the dome is covered and that the silage level is aligned with the edge of cup
2. Place the lid on the cup and try again
Q: I get a "Low Signal, Please rescan" error when scanning
The Cup battery is probably drained. Charge SCiO Cup. You can continue to scan during charging.
A:
Q: The light around the button is flashing yellow and red
A: The status light indicates the following:
1. Blue - flashing slowly - waiting for connection
2. Blue - flashing rapidly - just connected/disconnected/shut down
3. Blue - constantly on - connected and ready to scan
4. White - scanning/analyzing/calibrating
5. Orange - flashing slowly- pending calibration
6. Red - low battery
If any of the problems persist, please contact
investigate the issue and resolve it.
SCiO Cup QUICK REFERENCE GUIDE
and let us know. We will further
V1.3