- ページ 7

プロッター CONTACLIP EMS-ecoのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CONTACLIP EMS-eco 16 ページ。 Easy-marking-system

5. Operation

Once you have installed the EMS-eco and connected the power supply and data

cable, you can switch the plotter on.

Important:

Before switching the device on please ensure that there are no objects on the

writing/plotting area which might prevent the writing arm from moving freely.

All settings and commands are entered using the control panel.

Control Panel

Switch device on/off

Turn off the beep

reminder signal to re-cap

and store the plotter pen

ON/OFF buttons

The ON/OFF buttons are used to activate and deactivate the device. When the plotter

is switched on, the writing arm moves to the top right-hand corner of the labelling area

and auto calibration takes place. The green light comes on when the system is ready

for use and to receive data from the PC.

Clear buffer

If the EMS-eco contains data the yellow light will come on. You can delete this data by

pressing the 'Clear buffer' key.

To do this the system must be in stop mode (red light on).

Delete data

downloaded from PC

Pause or stop plotter

activity