- ページ 4

室内装飾品 Danze Cirtangular-Knightsbridge DF022224のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Danze Cirtangular-Knightsbridge DF022224 12 ページ。 24” freestanding vanity

ページを印刷する

2. Measure and mark with a pencil on the back

of your vanity (A) the location of the water

pipes and drain lines coming out of the wall.

3. Move vanity (A) away from the wall and cut

pipe holes on the back of the vanity (A) using a

hole saw.

4. Move the vanity (A) back to the intended in-

stallation location, flush against the wall.

5. Check the top of the vanity (A) for level front

to back and side to side. Adjust the height level-

ers on the bottom of the vanity (A) to achieve

level if necessary.

6. Use a pencil to mark on the finished wall the

location of the wall anchor holes that are on the

back of the vanity (A).

7. Move vanity (A) away from the wall and drill

1/4" holes for anchors (C) using 1/4" drill bit.

8. Remove screws (C1) and black washers (C2)

from anchors (C). Tap anchors (C) into the holes

until they are flush against the surface. Use a

hammer if necessary.