- ページ 9

アンプ Audiotec Fischer Match M 5DSPのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Audiotec Fischer Match M 5DSP 16 ページ。 5-channel, with integrated dsp

ページを印刷する

Installation

on the vehicle chassis, i.e. an area which has

been cleaned of all paint residues.

5. Connecting the remote input

The remote input (Remote In) has to be con-

nected to the remote output of the signal source

if the signal source which is connected to the

highlevel inputs is not activating the "automatic

activated / deactivated by a remote signal ap-

plied to the Remote Input.

We do not recommend controlling the remote

input via the ignition switch to avoid pop noise

during turn on/off.

6. Connecting the remote output

This output (Remote Out) is used to supply re-

connected to the Line Out of the M 5DSP. Al-

ways use this remote output signal to turn on

noises.

7. Connecting a subwoofer

The Subwoofer Output of the M 5DSP allows

to connect a passive MATCH Plug & Play sub-

woofer (like the MATCH PP 7E-D or PP 7S-D)

or a conventional subwoofer. Use only the

enclosed subwoofer cable for connecting a

cables may cause severe harm to the ampli-

Connecting a passive MATCH Plug & Play sub-

woofer:

1. Connect the 8-pole Molex connector of the

subwoofer cable (A) to the connection cable of

the MATCH Plug & Play subwoofer. (B).

2. Next, connect the 2-pole Molex connector of

the subwoofer cable to the Subwoofer Output

Connecting a conventional passive subwoofer:

1. Disconnect the ASIA plug connection of the

subwoofer cable (C).

2. Afterwards connect the loudspeaker cable of

the subwoofer (D) to the ASIA round plugs of

the subwoofer cable (E). Ensure that the loud-

speaker systems are correctly connected

(phase), i.e. plus to plus and minus to minus.

Exchanging plus and minus can cause a loss of

bass reproduction. The plus pole is indicated on

most speakers. The impedance of the connect-

ed subwoofer must not be less than 2 Ohms,

vated.

3. Finally connect the 2-pole Molex connector of

the subwoofer cable to the Subwoofer Output of