- ページ 6

ディスク・デュプリケーター Addonics Technologies HD9SITDRHSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Addonics Technologies HD9SITDRHS 10 ページ。 1:9 hs hdd duplicator pro

5. PreScan Source

Reads all blocks on the source drive to confirm no I/O errors are encoun-

tered.

6. ReScan BUS

Manually scans all ports and reports how many units were found.

7. Source Size

Examines the source drive and reports total space and space used, if

drive contains compatible partitions. Press up/down to change display,

ESC to exit.

8. Secure Erase

Scans all ports, then erases all data on all connected drives.

NOTE: some drives will remain in a locked state when the process is

complete. Drives that are locked may not appear to an operating system

and will cause an I/O error if used as a target in the duplicator. If this

happens, start secure erase again and hold ESC to cancel the operation

a few moments after it begins.

9. Overwrite

Overwrite is used to write data onto the entire hard disk, it will destroy all

data on all HDDs connected to the duplicator (including Source HDD) by

writing data to all sectors. There are 4 sub-options: One pass (zero), One

pass (random), 3 pass and 7 pass.

10. Setup

Enters the Setup menu. See Setup Options.

11. View Log

Shows the results from the most recent drive operation, such as copy,

overwrite, etc.

12. Adv Setup

Enters the Advanced Setup Menu. Only available by holding ESC on any

Main Menu option. See Advanced Setup Options.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/