- ページ 4
プリンター CONTACLIP TTPCardのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CONTACLIP TTPCard 11 ページ。 Thermal transfer printer
ページを印刷する
3.0
Discription
Layout:
1 - Green LED: power on.
2 - Yellow LED: printing cycle.
3 – Orange LED: error signal (see section 7).
4 - Green button: opening/closing carriage.
5 - Carriage.
6 - Lid.
7 - USB socket.
8 - Power supply socket.
9 - Power ON/OFF switch.
10 - Compartment with 2A phase and neutral protection fuses.
4.0
Initial set up
Carry out the following procedure step by step:
4.1
Connect the cables
•
Connect the USB cable between the PC and the USB socket (7) on the rear of TTPCard.
•
Check the supply voltage is correct then connect the power supply cable between socket (8)
on the rear of TTPCard.
•
Must be an EARTHED mains power supply.
•
The electrical socket of power supply cable must be easily accessible.
4.2
Switch the machine ON
•
Operate the ON/OFF switch (9) on the rear of TTPCard to commence the start-up cycle.
When the green LED (1) lights up, TTPCard is ready for use.
•
Do not press the green button (4) before the green LED lights up. If this happens restart
TTPCard (See section 7).
4.3
Install the GENIUSPRO operating software
•
The "CONTASign Pro" CD provided with TTPCard contains the driver and operating software
required. .
4.4
Open/close the carriage
•
Press the green button (4) on the front of TTPCard to open the carriage. Press the button
again to close the carriage.
•
Ensure there is sufficient space in front of TTPCard to allow the carriage to open completely.
•
Do not interfere with the carriage during opening and closing operations.
4