- ページ 12

スピーカーシステム Audiotec Fischer MATCH MS 8B-BMW.2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Audiotec Fischer MATCH MS 8B-BMW.2 17 ページ。 Car-specific

ページを印刷する

After the installation of the speakers you have to

connect them to the inline crossover networks. Fi-

nally you have to connect the original speaker cable

to the input of the inline crossover network. This re-

quires cutting off the original connector with pincers.

Never cut the cables directly behind the connector

MS 4B -BMW.2 Install

itself if you like to reconnect them at a later date.

The original speaker cables have to be equipped

with the crimp terminals. These crimp terminals

stick in the cables of the inline crossover network.

If you don't have a dedicated crimping tool you can

use combination pliers for fixing the terminals to the

original cables as well.

Installation of the MS 4B-BMW.2 / MS 4X-BMW.2:

Installation of the MS 8B-BMW.2

The installation of the under-seat subwoofers re-

quires dismantling the front seats of the car, each

fixed by four screws. Next you have to remove the

original speaker grilles, allowing accessing the woo-

fers themselves. Now replace the original woofers

by the new MATCH subs. For proper operation

of the subwoofers it might be necessary to partly

remove the foam around the speaker mounting

hole. After that you have to re-assemble the origi-

nal speaker grilles. Finally you have to reinstall the

front seats. Please double-check that you have tigh

ten each of the four mounting screws of each seat

properly!

Installation of the MS 8B-BMW.2:

MS 1T-BMW.2 Install

Installation of MATCH acoustic cloth

In order to protect the under-seat subwoofer

from dust we recommend to glue the included

12 x 12 inch MATCH acoustic cloth to the bottom

side of the original plastic grille.

You need an appropriate contact glue which is not

included in delivery.

Proceed as follows:

a) Place both grilles with bottom side up in front of

you

b) Clean the bottom side from dust and grease with

an appropriate cleaner (e.g. glass cleaner)

c) Apply glue onto the grilles' edge around the

sound holes

d) Put a MATCH acoustic cloth on each grille and

press it thoroughly until the cloth is plain without

wrinkles

e) Wait until the glue is hardened in order to cut the

overlapping cloth around the grille

f) For an easy installation pierce the mounting ho-

les of each grille with a sharp tool