- ページ 5

配管製品 Durastall 142のPDF 組立、設置、補修部品をオンラインで閲覧またはダウンロードできます。Durastall 142 6 ページ。 Shower stall

Apply a small bead of quality waterproof caulking (not

furnished) in track on Base – see illustration. Use the

Safety Rail to lift the panel unit and place into the track

against the caulking. It may be necessary to re-tap the

Corner Lock Strips to ease installation. (FIG. 5)

From the outside, insert a 1/4"-20 x 1/2" Truss Head Screw

in the Base and through the pre-punched hole in the Front

Support. Secure with a 1/4"x 20 Hex Nut on the inside.

Repeat for the remaining Front Support. Insert a #10 x 3/8"

Truss Head Tapping Screw into the pre-punched center hole of

the back panel (this will align the panel to the base.) Follow the

same procedure for both side panels. Tighten all three center

screws, then start the remaining six screws. After all screws are

started, tighten securely. (FIG. 6)

Set Top Frame in place and secure to panels and front supports

following the same procedure previously used for securing the

base. Note: A bead of silicone caulking on the top frame where it

meets the panels will help further seal the unit against leaks.

FIG. 7

CARE AND CLEANING

Your Shower Cabinet may be cleaned with a mild soap solution in warm water using a soft cloth. For stubborn

stains use Soft Scrub by Clorox or a powdered detergent such as Spic-n-Span. Never use abrasive scouring

powder or steel wool pads as they will dull and scratch the surface. A periodic coating of a silicone based marine

polish will help retain the fine finish of your unit.

WARNING! - Do not use spray on cleaners that require daily use without immediately rinsing to stop chemical reaction.

Damage of unit material will result and void warranty.

Set Threshold in place between the front support

extrusions. Be sure that threshold "notch" is locked

into base "tee" section. Insert a 1/4"-20 Hex Head

Screw through the pre-punched hole in the front

support flange and screw into the threaded area of

the Threshold. Follow the same procedure for the

other side. After both screws are started, tighten

securely. (FIG. 7)

FIG. 6

(If door is to be installed on unit, refer to instructions

provided with door assembly at this time.) Slide

Curtain Hooks onto Curtain Rod. Position Curtain

Rod over molded sockets on top surface of Top

Frame. Press Curtain Rod down to snap in place.

FIG.5

SI-188 (8•07)