- ページ 3
配管製品 Durastall 80のPDF 組立、設置、補修部品をオンラインで閲覧またはダウンロードできます。Durastall 80 6 ページ。 Shower stall
ページを印刷するNOTICE: Standard Base is for use with Mustee free-standing cabinets only! NOT for "built-in" alcoves!
STANDARD BASE
A.
Check shower base carefully making sure it is not damaged. Refer to the "rough-in" drawing and
determine location of shower base.
B.
Assemble drain to shower base (see illustration) using all washers provided. Do not use any putty or thread
sealant on either drain body or locknut. Hand tighten locknut, then wrench an additional 3/4 turn – maximum.
C.
Provide a 5" square opening in sub-floor or slab. This opening is to be located at center of shower base
location. Drain connection requires a 2" waste pipe (Schedule 40 PVC-DWV). Top of waste pipe must be
even with top of sub-floor or slab.
D.
Place shower base directly on sub-floor or slab. Make sure it is level!
E.
Seal waste by installing drain seal around 2 inch waste pipe. Tamp in place to bottom of drain body using a
1/4 inch diameter rod. Make sure top of drain seal is even with top of 2" waste pipe as shown in sectional
view and in full compliance with local code regulations pertaining to below floor waste connections.
PARTS ILLUSTRATION
SECTIONAL VIEW
STANDARD BASE
PARTS LIST
PART NUMBER
KEY
MODEL
NUMBER
80
1
70.102
2
70.207
3
42.309
4
42
5
80.140
6
32.214
7
42.319
8
32.207
9
42.305
Note: For missing or replacement parts, contact Mustee
Customer Service @216.267.3100
3
DRAIN SECTION
MODEL
140
DESCRIPTION
40.1030
Shower Base
40.210
Threshold
42.309
Strainer
42
Drain Seal
80.140
Drain Body
32.214
Sealing Washer - 1/16"
42.319
Sealing Washer - 1/8"
32.207
Fiber Washer
42.305
Locknut
SI-188 (8•07)