- ページ 13

マイクシステム Contacta STS-K015-01のPDF インストレーション＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Contacta STS-K015-01 16 ページ。 Speech transfer system

Factory Default Settings

To return to the factory default settings:

Unplug the power supply and then reconnect it.

2. Press the "On/Off" button and Volume In - button together, then release.

3. The status LED bar graph will show a fixed pattern of LEDs indicating the

firmware revision number, followed by all LEDs illuminated - this

indicates that the default settings have been restored.

To achieve the best possible performance, we recommend following the

below steps:

Ensure the customer and staff volumes are turned completely down

2. Adjust staff (Volume In) volume to a comfortable level

3. Increase customer (Volume Out) volume until feedback is heard

4. Decrease customer (Volume Out) volume until feedback is just eliminated

Once you have followed the above steps:

Ensure staff microphone is no more than

300mm away from the staff member when

sitting.

2. Check amplifier is fully functional by ensuring

the red 'fault' light is NOT showing on the front.

If there is insufficient volume, enter Engineer Mode and raise max volume

settings, then exit Engineer Mode and repeat initial setup.

The system is now ready to use. Speak into the microphone to converse easily

through glass.

Initial Set-Up

Staff

microphone